01.To check all accessories are completed or not.
02.Unscrew the screws (total 8 screws) which were located on the top & bottom cover.
03.To remove the protective wrap from bottom cover and then to lock the copper stud to the Bottom cover. Please make sure the cover’s front or back side.
04.To lock the HDD/SSD
05.To install the DC-ATX cable and SATA cable.
06.To lock the bottom cover.
07.To put the M/B inside the case. *due to the limitation of inner space, we suggest to install PW+PW LED switch first
08.To lock the M/B and adjust cables.
09.To install the Pico Power.
10.To install the DC Jack cable.
11.To organize the wires well.
12.To paste the rubber foot.
13.Completed the assembling.